The International Archives of the Photogrammetry, Remote Sensing and Spatial Information Sciences
Download
Publications Copernicus
Download
Citation
Articles | Volume XLIII-B1-2020
https://doi.org/10.5194/isprs-archives-XLIII-B1-2020-165-2020
https://doi.org/10.5194/isprs-archives-XLIII-B1-2020-165-2020
06 Aug 2020
 | 06 Aug 2020

DESIGNING AND BUILDING A COST-EFFICIENT SURVEY DRONE

H. Kauhanen, P. Rönnholm, M. Vaaja, and H. Hyyppä

Keywords: drone, camera, gimbal, design, simulation, assembly

Abstract. In this paper, we present a workflow how to design and implement a low-cost survey drone that meets the quality requirements of a much higher cost drone system. The technical specifications of available components and our design boundaries were applied in eCalc RC – xcopterCalc calculator in which the optimal setup was found by simulation. The main boundaries of design were derived from safety, operation time and payload capacity. Pixhawk 2 FCU, which is based on ArduPilot open source platform, was selected to handle autopilot and control functionalities. In addition, the system included a camera and a gimbal. The camera was controlled by FCU, which allows to geotag images using the on-board GPS data. The assembled survey drone was tested in a real survey mission. We successfully managed to complete a 13 minutes survey mission in mild wind conditions. According to simulation, the expected flight time range was between 9 and 15 minutes. In addition, simulation provided useful information on how the drone works under certain conditions such as working in extreme temperatures or high elevation locations as well as under heavy payloads. Even though our example was a survey drone, it is possible to use the same principles to design and implement a drone suitable for other tasks.