DETERMINING THE TECHNICAL STANDARDS OF PING PONG TABLE BY USING CLOSE RANGE PHOTOGRAMMETRY
Keywords: Metrology, Measurement, Rectification, Video, Non-Metric
Abstract. In the presented study, quality measurements were made regarding three different ping pong tables that were produced with three different materials. Measurements were made on the purpose of confirming whether the tables can be used as a match table that is in the standard of International Table Tennis Federation or not. For this confirmation, bouncing height of the table tennis ball is measured which is approved by ITTF. Average bouncing height that is required by federation standards is minimum 23 cm for free falling table tennis ball from 30 cm.
In order to locate the bounce on the tables, the table tennis ball is released from 30cm in free fall with equipment was. In the meantime, 24 video frames videos were shot with a Full HD (1920 × 1080) camera. Each frame of videos that were taken is separated from each other. Each frame is analyzed and highest bounce is measured.
As a result of the study, the bouncing heights of the three tables were measured as 23.04 cm, 23.33 cm, 22.91 cm for table1, for table2 and for table3 respectively.